Dog and House Animation

3D modeling is different from 2D modeling in the way you go about making your work. For the dog house you start off with a rectangle and use the push-pull tool to pull the rectangle up into a block. Then you create a smaller rectangle on the front of the block and use the push-pull tool again to pull in the rectangle. After this you use the two-point arch to make an arch at the top and again use the push-pull tool to push that in. After doing this use the line tool to create a line down the middle of the top of the block and use the move tool to pull the line up, making a roof. Using the offset tool can make it easier to create a trim-like appearance. After this you use the paint tool to color your house. I got the dog and cat from the "Get Models" tool. For the chair it was a bit more difficult because you had to use many different tools to create the back of the chair and then the chair legs. I decided to make the chair legs a bit more complicated to create a fancy appearance.